Kia Cadenza Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
742 Posts
Discussion Starter #1

·
Registered
Joined
·
742 Posts
Discussion Starter #2
Such a simple upgrade...but man does it make a difference. I can now used the door pockets and not hear my junk around every turn stop/start!


Rear doors worked pretty easy, just went with 2.5 inches wide by 13. Tapered it a little once it was dry fit, and boom in it went.


Fronts were a lot more of a challenge, as I recall 3.5 X 18 roughly, so that really only gave me option for 3 pieces from the roll, or I'd be forced to break it up, which I wanted to avoid. So dry fit, line up the cup holder, opened up the slits, and it actually worked out really nicely. Ended up getting both sides done without mistakes.

I tell ya, they use way too much armoral on the car when detailing at the dealership. I had to use some 409 to clean the inside of the door or the adhesive would not have stuck. To be honest, that prep was the hardest part of the job...
 
1 - 2 of 2 Posts
Top